Show Control
109
1.
From the Input/Output screen in Setup, arrow down to "DMX
Input"
2.
Use the arrows to set the Input Protocol to DMX if you're using the Aux
connector on the rear of the unit.
3.
Use the arrows to select the Memory Page.
4.
Use the arrows to select the first Memory (Memory Offset) in the
selected Memory Page you want to control with the first slot of DMX.
5.
Choose either
Slider
or
Button
.
•
Slider control will map the incoming DMX value to the level of
the Memory
•
Button mode will hold the button down for any non-zero DMX
level. It's best to keep the Memory Bump Mode "Momentary"
when using this mode.
6.
Press Apply
.
NOTE
You can also receive eDMX from controllers using the Pathport Protocol,
sACN E1.31 or Art-Net by changing the Input Protocol from DMX. In that
case you must choose a Universe number as well from the edit box which
will appear when the Input Protocol is not DMX.
Summary of Contents for choreo
