Parallax ELEV-8 V2, Assembly Manual

Page: 76 / 130

3. Rotate the roller to “Model Type” and click once. Select “Acro” by rotating the roller to
highlight it and click once. When prompted "Data will be reset", select "Yes".
4. Scroll to “Model Name” and click once. Use the roller to name your model (we suggest
“ELEV-8 V2”); scroll until the cursor is under the character you wish to edit, the click
once; scroll until the character you want appears, then click again to save. Scroll to move
the cursor to the next character and repeat. Once done, scroll to "Back" in the
upper-right corner and click.
5. Scroll to "Main" in the upper-right hand corner and click once.
6. With the transmitter powered on and in the main screen, press and release the roller to
enter the “Function List.” Rotate the roller to the right until “Servo Setup” is highlighted
and click once.
a. Scroll right to "Throttle" and click once. Scroll right until "Aileron" appears then
click again. Scroll right to "100% 100%" and click once. Scroll left until "50%
50%" is displayed, then click again.
b. Scroll left to "Aileron" and click once. Scroll right until "Elevator" appears then
click again. Scroll right to "100% 100%" and click once. Scroll left until "50%
50%" is displayed, then click again.
c. Scroll left to "Elevator" and click once. Scroll right until "Gear" appears then click
again. Scroll right to "100%" and click once. Scroll left until "25%" is displayed,
then click again. Locate the "Gear" switch on the top left of the unit and switch it.
The highlight box on screen should now highlight the other "100%", click once.
Scroll left until "25%" is displayed, then click again. Set the "Gear" switch to the
"0" position.
​ You will need to keep this switch in the “0” position for normal flight
operation.
Instructions for ORX T-SIX Configuration
1. Turn ON the transmitter by “sliding” the power switch up.
2. Click the roller once to access the “Function List”.
3. Scroll right to highlight “Model Select” and click again.
4. Scroll right until you find an empty model (There should be nothing written under “model
#”)
5. Exit “Model Select” by scrolling left until the “left arrow” is highlighted.
6. Click on the left arrow with the roller
7. You should now be back in the “Function List”.
8. Scroll right to highlight “Setup List” and click again.
9. Scroll right to highlight “Model Type” and click once.
10. Select “Arco”.
11. Scroll left to highlight the “left arrow” and click once to return to the “Setup List”.
12. Select “Model Name” and click once. Use the roller to name your model. We suggest
ELEV 8V2.
13. Once you're done naming your model, return to the “Setup List” by highlighting and
clicking on the “left arrow” once.
Copyright © Parallax Inc. ELEV-8 V2 Assembly Guide
07/26/2018