Panasonic HL-C2 Series, User Manual, Page: 93 / 278

Chapter 4 Explanation of Functions
4-19
4
■ Calibration
This function corrects the deviation of the measurement value caused from
the color, material, or surface condition of the measurement object.
As shown below, the value can be corrected by setting two points of “a” and
“b” respectively to the point “A” and “B”. The point “A” means the actual
measurement value, and the point “a” means the correction value. The point
“B” and the correction value “b” can be set as same as the above.
Before setting the calibration, be sure that the timing input, offset, and zero
set is set to “OFF”, the analysis mode is set to “NORMAL”, OUT1 is set to
“A” and OUT2 is set to “B” for the output selection. Then, perform the
calibration setting in the appropriate measurement mode.
● How to use
1
Display the “Calibration” screen.
2
Touch the
Change
key.
The screen is changed.
Touch each key to change the screen.
Meas A
---
Measurement value A input screen
Corr a
---
Correction value a input screen
Meas B
---
Measurement value B input screen
Corr b
---
Correction value b input screen
Load (top)
---
Measurement value A load screen
Load (bottom) Measurement value B load screen
Measurement range
Output
A
B
Measurement value A

: Measurement value

: Correct value
a
b
For inputting the measurement
value or correction value
For loading the measurement
value from the current value
Key Screen
Measurement value A
Correction value b
Correction value a
Measurement value
Correction value
Setting screen of sensor head A Setting screen of sensor head B