Panasonic HL-C2 Series, User Manual, Page: 153 / 278

Chapter 4 Explanation of Functions
4-79
4
■ Buffering Type
This function selects individual data accumulation or simultaneous data
accumulation on OUT1 and OUT2.
OUT1 is set as a default.
The maximum accumulation data amount differs depending on buffering type.
■ Buffering Rate
The buffering rate can be set for accumulating the measurement data for a
long-duration by taking an adequate interval to the sampling cycle.
Select from 1 (All measurement data), 1/2, 1/4, ......to 1/32768.
1(All measurement data) is set as a default.
(If selecting 1/4, the measurement data is accumulated only at once in four
sampling cycles.)
All the measurement data can be accumulated, however, in case that the
deviation amount of the measurement data is small to a sampling cycle, setting
the data accumulation interval can execute a long-duration data accumulation
than measurement at every sampling cycle. This is useful for the effective use of
memory since the data accumulation amount is limited.
■ Accumulation Amount
This function sets the accumulation amount of the measurement data.
Specify the accumulation amount within
1 to Max. accumulation amount
.
Maximum accumulation amount is different between two buffering types.
OUT1 or OUT2 ·········· Max accumulation amount = 65,000 data
OUT1 & OUT2 ·········· Max accumulation amount = 32,500 data
“20000” is set as the default.
Accumulation cannot be started when the setting of the range of “accumulation amount”
for each “buffering type”, settings of “trigger point” and “sample trigger accumulation
amount” corresponding with the “accumulation amount” are not correct (out of the
setting range).