Panasonic FP0H Series, User Manual, Page: 122 / 200

Instruction References
7-30
Operation result storage area
Operand Settings Description
⑤
S+12
X-axis Component speed
Initial speed Fxmin
The component speed (initial speed and maximum speed of
each axis) is stored as 2 words in real type.
(Composite speed) × (X-axis movement amount)
X-axis component speed =
((X-axis movement amount) 2 + (Y-axis movement amount) 2 )
(Composite speed) × (Y-axis movement amount)
Y-axis component speed =
((X-axis movement amount) 2 + (Y-axis movement amount) 2 )
Example) Even when the initial speed is corrected, the
calculated value is stored as is in the operation result storage
area.
S+14
X-axis Component speed
Maximum speed Fxmax
S+16
Y-axis Component speed
Initial speed Fymin
S+18
Y-axis Component speed
Maximum speed Fymax
⑥
S+20
X-axis
Frequency range
The frequency ranges are automatically selected by the system
for the components of each axis.
0: Low speed range (1 Hz to 22 kHz)
1: High speed range (50Hz to 100 kHz)
When the initial speed (X/Y axis) is the low speed range and the
maximum speed (X/Y axis) exceeds 22 kHz, the initial speed
(X/Y axis) is corrected to 50 Hz.
When the initial speed (X/Y axis) is less than 1 and the
maximum speed (X/Y axis) exceeds 22 kHz or less, the initial
speed (X/Y axis) is corrected to 1 Hz.
S+21
Y-axis
Frequency rangec
⑦
S+22
X-axis
Acceleration/deceleration
steps
The acceleration/deceleration steps are automatically calculated
by the system in the range of 0 to 60 steps.
・
When the operation result is 0, the pulse output is
performed at the initial speed (composite speed) without
acceleration and deceleration.
・
The acceleration/deceleration steps are calculated by the
following formula; Acceleration/deceleration time (ms) x
Initial component speed (Hz).
Example) When the settings are as follows; Incremental, Initial
speed=5 kHz, Acceleration/deceleration time=0.5 s, CH0 target
value=1000, and CH2 target value=50.
(1000
2
+50
2
)
= 299.626 Hz
300×1000
(1000
2
+50
2
)
= 14.981 Hz
300×50
CH0 Initial component speed =
CH2 Initial component speed =
CH0 Acceleration/deceleration steps = 500x10 -3 x299.626≈147.8 60 steps
CH2 Acceleration/deceleration steps = 500x10 -3 x14.981≈7.4
7 steps
S+23
Y-axis
Acceleration/deceleration
steps

Supplement to pulse output operation
When outputting pulses with the PLS+SIGN (direction output) method, pulses will be output
approx. 300µs later after the output of direction signal (SIGN). (The characteristics of a motor
driver is considered.)