OPTIMUM
M A S C H I N E N - G E R M A N Y
808D
Page 322
Operating and Programming — Milling
Workpiece Setup
Brief instruction 808D Milling
SEQUENCE
The tool setup and workpiece setup must have
been performed correctly so that it can be
tested as follows!
Press the “Machine” key on the PPU
Press the “MDA” key on the MCP.
In order to ensure the machine safety and correctness, the results of the tool offset
should be tested appropriately.
Press the “Delete file” SK on the PPU.
Enter the test program recommended on the right.
(can also be customized)
G54 (select offset
panel as required)
T1 D1
G00 X0 Y0 Z5
Press the “ROV” key to ensure the “ROV” function
is active (lit up).
Note: The ROV function activates the feedrate override switch under the G00 function.
Make sure the feedrate override on the MCP is at 0%!
Press “CYCLE START” on the MCP.
Increase the feedrate override gradually to avoid accidents caused by an axis moving
too fast. Observe whether the axis moves to the set position.
Test tool
offset results
Delete
file
