User interface, machine control panel
Version 1.1.2 dated 2019-05-07
Page 263
Translation of the original instructions
F80 | F105
GB
F
80_F105
_GB
_5.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
Protection level 1
Protection level 1 requires a manufacturer password. With this password entry, you can per-
form the following operations:
Entering or changing all machine data
Conducting NC commissioning
Protection level 3-6
Protection level 3-6 requires an end-user password. With this password entry, you can perform
the following operations:
Entering or changing part of the machine data
Editing programs
Setting offset values
Measuring tools
Protection level 7
Protection level 7 is set automatically if no password is set and no protection level interface sig-
nal is set. The protection level 7 can be set from the PLC user program after you set the bits in
the user interface.
In the menus listed below the input and modification of data depends on the set protection
level:
Tool offsets
Work offsets
Setting data
RS232 settings
Program creation / program correction
5.4.1
Passwords
INFORMATION
Usually the machine operator does not need to change the password.
5.4.2
Change passwords
Step 1
The service mode is opened with the appropriate key combination. In the service mode, the
password can be activated and deactivated.
Press
Shift+ System Alarm
Step 2
Enter customer’s or manufacturer’s password.
Change customer’s or manufacturer’s password.
Delete customer’s or manufacturer’s password.
Set
password
Change
password
Delete
password
Set
password
Change
password
Delete
password
