OPTIMedical OPTI CCA-TS, Operator'S Manual, Page: 38 / 271

2-10 Operator’s Manual – OPTI CCA-TS
2 SETUP
Fig. 2-21 tHb Calibration
After the cover has been closed, the instrument
will automatically detect the presence of the
calibrator cassette and begin calibration
(Fig. 2-21).
• After the calibration is complete you will be
prompted to open the sample chamber cover
and remove the cassette.
• Place the calibrator cassette back into its
pouch immediately after removal from the
instrument.
NOTE: Make sure to keep the calibrator
cassette with the instrument at all times.
The unit will now begin printing the tHb
Calibration Report showing calibration results
and calibration factors (Fig. 2-22).
Fig. 2-22 HbCal Report
OPTI Medical OPTI CCA
Calibration Report
DD-MMM-YY HH:MM
S/N: XXXX
Version: ABCX.XX
Operator ID:
HbCal Type: tHb-Calibrator
HbCal LOT: XXXXXX
HbCal Date: DD-MMM-YY
Calibration Results:
Meas’d Cal’d
tHb 12.9 13.0
S02(%) 74.6 74.9
Calibration Factors:
OLD NEW
F1 1.023 1.014
F2 1.087 1.080
F3 1.089 1.094
F4 0.000 0.000
OPTI Medical recommends that you run controls prior to running patient samples on a new
analyzer. You must set up your SRCs and OPTI Check control lot information in your new
analyzer prior to running them. The SRCs can be found in the storage compartment in the back of
your analyzer.
Refer to section 3.3.1 of this manual for the QC Setup procedure. Refer to section 4.5 of this
manual for QC recommendations and instructions for running QC measurements.
Congratulations!
Your OPTI CCA-TS analyzer is now ready for operation.