OPTIMedical OPTI CCA-TS, Operator'S Manual, Page: 119 / 271

Operator’s Manual – OPTI CCA-TS 7-1
7 DIAGNOSTICS AND TROUBLESHOOTING
7 DIAGNOSTICS AND TROUBLESHOOTING
Your OPTI ™ CCA-TS Analyzer is designed to provide trouble-free service.
However, any measuring device may occasionally malfunction requiring you to identify the cause
of the problem and initiate corrective action.
This chapter describes OPTI CCA-TS specific error messages and recommends steps that should
return your OPTI CCA-TS to operation.
If your OPTI CCA-TS does not perform correctly after conducting the basic steps outlined in this
chapter, you should contact OPTI Medical Systems for technical assistance.
7.1 Error Displays
The sensors did not see any sample. Make sure
sample is properly attached and not clotted and
does not contain air bubbles. Wait for the system to
recalibrate.
• Remix sample carefully.
• Press to notify the system that the
sample is reattached and reaspirate sample.
The displayed measured parameter is unstable.
NOTE: This message is a warning. The analyzer will,
however, display a result for the parameter
concerned.
• Remove cassette and check for aspirated bubbles.
• If bubbles are present over a sensor, do not report
that parameter.
The displayed sensor is bad.
•
You have the option of continuing the
measurement by pressing
or stopping
by pressing . If you continue,
no results will be provided for the bad sensor
or any calculated result, which utilizes this
measurement in its calculation.
WARNING! - No Sample Detected.
OK
WARNING! - No Sample Detected.
OK
WARNING! - Bad Sensor - pH.
OK Cancel
WARNING! - Bad Sensor - pH.
OK Cancel
WARNING! - Unstable pH.
Check Cassette.
OK
WARNING! - Unstable pH.
Check Cassette.
OK