![background image](http://html1.mh-extra.com/html/omron/v700-series/v700-series_operation-manual_743606032.webp)
2-3
Section
ID Tags
20
2-3-4 V700-A80 Attachment for the V700-D
j
3P31(-Y) ID Tags
The V700-A80 Attachment is a special attachment bracket that can be used to
attach a coin-shaped ID Tag to a workpiece. It is compatible with the
V700-D
j
3P31(-Y) coin-shaped ID Tags.
V700-A80 Dimensions
Mounting Hole Dimensions
Two 6 dia countersinks
Two 3.5 dia holes
Two M3 holes
40
24
18
31
±
0.2
1
22
3.5
8
5
22
31
±
0.2
Installation Procedure
1, 2, 3...
1. Set the coin-shaped ID Tag into the V700-A80 Attachment. The coin-
shaped ID Tags are not directional, so the ID Tag can be installed with either
side up.
2. Screw the Attachment to the workpiece with M3 screws. Tighten the screws
to a proper torque (0.3 to 0.5 N
@
m).
The Attachment’s specifications meet or exceed the ID Tag’s specifications.
When the ID Tag is mounted in a V700-A80 Attachment, there is an 8-mm gap
between the ID Tag and the mounting surface. If the workpiece is metal, refer to
9-5 Influence of a Metal Surface behind the ID Tag for details on the effects of the
metal surface on communications.
Do not install and remove the ID Tag repeatedly. Doing so will weaken the hold-
ing power of the Attachment and there is a risk of breaking the Attachment’s
holding clips.
If the ID Tag must be removed from the Attachment, it can be removed by insert-
ing a flat-blade screwdriver in the gap between the Tag and Attachment (on the
bottom of the Attachment) and gently prying out the Tag. Do not attempt to re-
move the Tag with your bare fingers; you may cut yourself.
General Specifications
Mounting on Metal
Precautions
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]