![background image](http://html1.mh-extra.com/html/omron/v700-series/v700-series_operation-manual_743606011.webp)
!
!
!
7
EN/IEC Standards
xiii
•
Be sure that all the mounting screws, terminal screws, and cable connector
screws are tightened to the torque specified in the relevant manuals.
•
Use crimp terminals of specified size for wiring.
•
Be sure that the items with locking devices are properly locked into place be-
fore using the System.
•
Be sure that the DC Power Supply Unit exclusively designed for the V700 Se-
ries is used and is not connected to any other device.
•
Be sure that the power supply voltage is within the rated range of 24 VDC+10%
and –15%.
•
Do not remove the ferrite cores attached to the V700-H01 and V700-H02.
•
Install the ferrite core supplied with the V700-CD1D-V3 or V700-CD2D-V3 ac-
cording to the specified instructions.
•
Be sure to observe all warnings, cautions, and safety precautions specified in
the manual.
5
Correct Use
Caution
Do not install the V700-H01, V700-H02, V700-CD1D-V3, or V700-CD2D-V3 in
the following locations:
•
Locations subject to direct sunlight.
•
Locations subject to condensation as the result of severe changes in tempera-
ture.
•
Locations subject to corrosive or flammable gases.
•
Locations subject to shock or vibration.
Caution
Be sure to observe the following wiring precautions:
•
Do not wire the lines of the RFID System alongside high-tension or power
lines.
•
Check the polarity of each terminal and make sure not to make mistakes in po-
larity.
Caution
Be sure to observe the following precaution when cleaning the V700-H01,
V700-H02, V700-CD1D-V3, or V700-CD2D-V3:
•
Organic solvents may damage the paint coating on the casing or resin part of
the product. Do not use paint thinner or any other organic solvent to clean the
product.
6
Applicable Standards
The V700-series Electromagnetic Inductive RFID System conforms to the fol-
lowing standards:
•
EC Directives EN50081-2
•
EC Directives EN50082
7
EN/IEC Standards
•
In connection with EC unification, eighteen European countries will integrate
their conventional safety standards into EN standards. When the EN stan-
dards come into effect, they will apply as the unified European standards in
place of the conventional safety standards.
•
EN standards are based on IEC standards. Therefore, machines that are ex-
ported to Europe from Asia or North America must satisfy EN standards.
Otherwise, the machines must satisfy IEC standards if the machines do not fall
under EN standards.
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]