4-3
Section
ID Tag
57
Be sure to ground switching power supplies and keep them as far away as pos-
sible from the Antenna.
If the Antenna is still influenced by noise in spite of the above countermeasures
taken, the communications range must be reduced.
The Controller in stable communications mode rather than long-distance mode
withstands more ambient noise although the communications range decreases.
Note Keep the above in mind before installing the Antenna. Before the Antenna is put
in actual use, be sure to conduct enough tests of the Antenna.
4-2-2 Mounting the Antenna
Be sure to attach the provided bracket to the Antenna and mount the Antenna
with four, M4 screws with spring washers and flat washers as shown below.
V700-H01
V700-H02
Center of coil
Four, M4 or 4.5 dia.
Center of coil
Four, M4 or 4.5 dia.
Coil
Spring washer
Flat washer
Bracket
Spring washer
Flat washer
Bracket
185
±
0.2
235
±
0.2
142.5
185
±
0.2
343
635
±
0.2
4-3
ID Tag
4-3-1 Installation Environment
Do not install ID Tags in the following locations.
•
Locations with corrosive gas, flammable gas, dust, or metal powder
•
Within an electronic oven
4-3-2 Mounting Method
Observe the following guidelines when mounting ID Tags.
•
Do not machine, cut, or open holes in the ID Tag.
•
Do not impose excessive force on the ID Tag,
•
Do not mount the ID Tag on or nearby metal objects.
Switching Power
Supplies
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]