4-1
Section
Controller
52
Connection and Disconnection of Connector
•
When connecting the connector, be sure to hold the connector by hand and
insert the connector. Then secure the connector with two lock screws.
•
When disconnecting the connector, completely loosen the two lock screws.
Then hold the protruding part of the connector hood by hand and pull the con-
nector straight out. If the connector is difficult to disconnect, hold the Controller
by hand while pulling out the connector.
Philips screwdriver
Lock screw
Note Example of Grounding from Controller
Controller
Host Computer
•
The shielded wire must be grounded either from the Controller or the host com-
puter for the prevention of system malfunctions. The above is an example of
grounding from the Controller.
•
Short-circuit the RS and CS pin in the connector.
4-1-7 Connection of the RS-485 Interface (V700-CD2D-V3 Only)
The following diagram shows the configuration of the RS-485 interface. Termi-
nal 1 is connected to terminal 3 within the RS-485 controller and terminal 2 is
connected to terminal 4.
Terminal
Terminal
Polarity
1
2
3
4
1
2
3
4
+
–
+
–
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]