Unit 8 IDA Business Park, Whitestown, Tallaght, Dublin 24, Ireland.
Telephone: 353 1 462 2585. Telefax: 353 1 462 2587. E-mail: [email protected] Web: www.actrl.com
ACTLAN Interface Configuration
ACTWin Pro Software
1. Ask the network administrator to supply you with a permanent IP network address.
2. Connect a PC directly to the ACTLAN and run HyperTerminal at 9600 baud, no parity, 1 stop.
3. Power up the ACTLAN and
immediately
hit 3 lowercase "x" (xxx).
4. Hit the Enter key to go inte Setup Mode.
5. Select 0 and follow the prompts until you get to IP address.
6. Enter the new IP address.
7. If the ACT controllers are on a different LAN segment to the ACTWin Pro PC, then a Gateway
Address is required. Check with the network administrator for the IP address of the router.
8. A Netmask may also be required. Check with the network administrator.
9. Follow the prompts to come back to the Setup Menu.
10. Select 1 to configure the RS232 channel.
11. Set up the following parameters as follows:
Baud Rate
9600
I/F Mode
4C for Direct Connect,4F for Network
Flow
00
Port
10001
Connect Mode
C0
Disconnect Mode
00
Flush Mode
80
Pack Control
00
Remote IP Address
none
12. Return to the Setup Menu and select 9 to save the settings.
13. Finally test the setup by connecting to the IP address using a Web browser or 'Pinging'.
14. From ACTWin Pro, enter the new IP address into the location manager for the site.
18-00026 Issue 4
ser
ial
10B
ASE-T
9-30v
link
net
Tx/Rx
collision
diagnosit
c
sta
tus
LAN/WAN
A B 0V
TX
RX
NETWORK
DOORS
A
B
0V
SERIAL/PRINTER
0V
DTR
DB25 Male
(Rear View)
7
3 2
Max cable length is 5m using standard
alarm cable or 30m using twin twisted-pair
(use 0V in each pair)
Connections for 25 Way male Connector
RX = Pin 3
TX = Pin 2
0V = Pin 7
ACT 2000
TCP/IP Configuration
Connections for Direct Connect
Connections for Network
1. Connect cable directly to
ACT1000/2000 and LAN device
2. In Communications Menu Set:
Address = 1
Direct Conn = Y
ACT 2000
1. Connect LAN RS-485 cable to
NETWORK terminals on the
controller and LAN Interface
2. In ACT1000/2000 Communications
Menu set the controller Address and
set Direct Conn = N
A B 0V
NETWORK
DOORS
A
B
0V
7
22 21
15 14
DB25 Male
(Rear View)
A = Pin 14
B = Pin 15
0V = Pin 7
Pin 14 = Pin 21
Pin 15 = Pin 22
ACT, Unit C1, South City Business Centre, Tallaght, Dublin 24, Ireland. www.accesscontrol.ie
Telephone: 353 1 466 2570 UK Lo-Call 0845-300 5204 Fax: 353 1 452 0427 E-mail: [email protected]
