Omron SYSMAC C200H-IDS01-V1, Operation Manual

Page: 22 / 114

7
System Connections
Section 1-5
C200H-IDS01-V1 Electromagnetic Induction ID Sensor
C200H-IDS21 Microwave ID Sensor Unit
1-5 System Connections
Mounting the ID Sensor
Unit As a Special I/O Unit, an ID Sensor Unit can be mounted to any slot on the
C200H PC Backplane except the two rightmost slots; these two slots are
reserved for peripheral devices.
Up to ten Special I/O Units can be mounted to a PC system. (The PC Link
Unit, used to link two PCs, is a Special I/O Unit.) The number of ID Sensor
Units which can be connected may be limited by the size of the Backplane,
the Power Supply, and the current consumption of each Unit. For details, refer
to the
C200H Programmable Controller Installation Guide .
Mounting to a Remote I/O
Slave Rack The maximum number of Special I/O Units that can be mounted to a Remote
Slave Rack differs depending on the group (A, B, C, or D, as shown in the fol-
lowing table) to which they belong.
C200H
ID Sensor Unit
C200H
Connecting Cable
Read/
Write Head
Read/Write
data
Data Carrier
Work
piece
Movement
Work
Hand-held Programming Console
(Attach the keyboard accessory
sheet, supplied with the ID Sensor
Unit, to the Programming Console.)
Read/Write
Head
C200H
ID Sensor Unit
C200H
Connecting Cable
R/W
Antenna
Read/Write
data
Data Carrier
Work
piece
Movement
Work
R/W
Antenna
Hand-held Programming Console
(Attach the keyboard accessory
sheet, supplied with the ID Sensor
Unit, to the Programming Console.)