Omron SYSMAC C200H-IDS01-V1, Operation Manual

Page: 70 / 114

55
Monitoring
Section 3-2
Initial Display When the mode selector is in the MONITOR mode, the following message is
displayed:
Note When the Programming Console is in MONITOR mode and the buzzer is
enabled, only the following keys are functional:
RESET Display Press the RESET key to return the screen to RESET status. Press the
RESET key either after a monitoring operation has been completed, or during
a monitoring operation to abort that operation.
The following message is displayed when the RESET key is pressed:
Error log display Use this command to display
errors that occurred while the
ID Sensor was in RUN mode.
Error messages and
corresponding codes are
displayed, and errors are
classified as either “newest
error” or “statistical error”.
Monitor command Function Key sequence
4
3
2
ERR INC
DEC
3
4
SET
SET SET
1
1
2
(Date change)
: displays newest error information
: displays statistical error information
: clears newest error information
: clears statistical error information
<MONITOR> BZ
Indicates that the buzzer is enabled.
Press the "B" key to alternately enable or
disable the buzzer.
JOB DATA RESET ADRS
B
HEAD 1 PAGE 0A
STadrs00 data 00
The number of the
Read/Write Head
connected to the
ID Sensor Unit.
Usually fixed to 1.
(See notes below.)
Address
ST: Start address
ED: End address
Address page number
(Refer to
Address Page
Numbers below.)
Data
RESET
C200H-IDS01-V1
HEAD 1 PAGE 00
STadrs00 data 00
The number of the
Read/Write Anten-
na connected to
the ID Sensor Unit.
Usually fixed to 1.
(See notes below.)
Address
ST: Start address
ED: End address
Address page number
(Refer to
Address Page
Numbers below.)
Data
RESET
C200H-IDS21