Omron SYSMAC C200H-IDS01-V1, Operation Manual

Page: 27 / 114

12
Switch Settings
Section 2-1
Section Overview
This section contains information on switch settings, bit allocation, and setup
of both ID Sensor systems, as well as explanations of the user program, com-
munication commands, and the write-protect function.
2-1 Switch Settings
Unit Number Switch Before beginning operation, use the unit number switch on the front panel to
set the unit number (0 through 9) of the ID Sensor Unit. Each Special I/O Unit
must be assigned its own number; if the same number is assigned to more
than one Unit, an I/O Unit Over error will occur, preventing system operation.
To set the unit number:
1,2,3... 1. Determine the appropriate unit number (refer to 1-5 System Connections
for information on Special I/O Units).
2. Turn OFF the power to the PC.
3. Using a small standard screwdriver, turn the dial to the desired number.
The dial clicks into position at each number setting; do not leave the dial
between settings.
Back Panel DIP Switch (Refer to the diagram of the back panel on page 5.) Pin 1 is used to select the
language of the Programming Console display; leave this pin at the ON (left)
position for English message display. Pins 2 through 4 are for reserved for
expansion; leave these pins at the OFF (right) position.
Indicators
Unit number switch
(MACHINE No.)
IDS01-V1
MONITOR
MACHINE
No
ANTENNA