Omron NYP17-*-11 SERIES, User Manual

Page: 146 / 264

5-3-9
Mount the Panel PC
Ensure the panel cut out is ready before beginning the mounting procedure.
Tools required: Torque screw driver with hexagon 2 mm bit.
The Panel PC is equipped with 8 retractable mounting brackets A on the back of the Panel PC.
These brackets are used to fasten and secure the Panel PC to the mounting surface.
Use the following procedure to mount the Panel PC to the mounting surface:
1
Ensure all 8 retractable mounting brackets A are in the retracted position
1
. If required press
the mounting brackets in the retracted position and hand tighten the allen bolt
2
.
0
15
A
B
1
2
3
The left image shows a Panel PC with passive cooling. The right image shows a Panel PC with
active cooling.
2
Insert the Panel PC into the mounting surface cut out so the bezel B touches the mounting
surface.
3
Loosen the allen bolts
2
of the mounting brackets.
The mounting brackets are spring loaded and will extend
3
when loose.
4
Ensure all mounting brackets extend to overlap the mounting surface.
5
Tighten all mounting brackets to a torque of 0.6 N·m to maintain water and dust resistance.
Precautions for Safe Use
The mounting panel must be between 1.6 and 6.0 mm thick. Tighten the mounting brackets
evenly to a torque of 0.6 N·m to maintain water and dust resistance. If the tightening torque ex-
ceeds the specified value, or the tightening is not even, deformation of the front panel may oc-
cur. Additionally, make sure the panel is not dirty or warped and that it is strong enough to hold
the product.
5 Installation
5 - 26
NY-series Industrial Panel PC User's Manual (W555)