Omron G3PW, User Manual

Page: 59 / 120

44
Setting Parameters in the Initial Setting Level Section 4-6
Parameter Settings Related to Auxiliary Inputs
Main Setting Input Parameter Settings
The following table shows the relationship between the parameters related to
inputting the main settings.
or
External Duty Input Enable/Disable
[P01]
Output mode
Proportional to
phase angle
(same as G3PX)
Proportional to
square voltage Proportional
to voltage
Constant-
current control
Optimum cycle
control
ON/OFF control
Parameter
Internal Duty only
[P01] = 0#
or
Setting enabled by external variable resistor.
[P01] = 1
Set the Input Digital Filter
Time Constant.
0.0 to 100 ms
[P03] = 0.0#
or
Input Digital Filter Time Constant
[P03]
Event Input Assignment
[P11]
No Assignment
[P11] = 0#
Phase Control and Optimum
Cycle Control Selection
[P11] = 1
Main Setting
Automatic/Manual Selection
[P11] = 2
To settings related to protective functions
#: Default
*: Setting disabled
Main Setting
Automatic Input
Selection [P05]
Main Setting
Manual Input
Selection [P06]
Event Input
Assignment
[P11] 0 (No assignment)
or
1 (Control method
selection)
Main Setting
Automatic/
Manual
Default [P08] 0 (Automatic)
Main setting input using
linear input or commu-
nications.
0 (4 to 20 mA or 1 to
5 V) ---
1 (Communications) ---
1 (Manual)
Main setting input using
an external variable
resistor or using key
operation.
--- 0 (External variable
resistor)
--- 1 (Key input)
2 (Main setting
automatic/manual
selection) Event input
Open (Automatic)
0 (4 to 20 mA or 1 to
5 V) ---
1 (Communications) ---
Event input
Closed (Manual)
--- 0 (External variable
resistor)
--- 1 (Key input)