APPLIED OPERATIONS
/Image Acquisition
OPERATION INSTRUCTIONS
2 - 5 1
Page
2-2-2-5 XYT Observation Mode
The description in this section will be focused on the image acquisition operations in the XYT
observation mode that are not used in the XY observation modes (which are the operations
enclosed in
in the chart on the next page). For other operations, see section 2-2-1,
“Image Acquisition in XY Observation Mode”. The details of each operation will be described
in the subsequent sections.
Save image.
(Section 2-3-1 in [OPERATION])
Set the zoom ratio to 1X.
(Section 2-2-1-4-2 in [OPERATION])
Set the objective magnification.
(Section 2-2-1-4-1 in [OPERATION])
Set the dyeing method.
(Section 2-2-1-1 in [OPERATION])
Set the channel to be acquired.
(Section 2-2-1-4-3 in [OPERATION])
Set the highest scan speed.
(Section 2-2-1-4-4 in [OPERATION])
Perform repeated scanning.
(Section 2-2-1-4-6 in [OPERATION])
Set the XY observation mode.
(Section 2-2-1-4-5 in [OPERATION])
Set the observation range.
(Section 2-2-1-4-8 in [OPERATION])
Adjust the Z-position to observe the
desired cross-section.
(Section 2-2-1-4-7 in [OPERATION])
Set a lower scan speed.
(Section 2-2-1-4-10 in [OPERATION])
Stop repeated scanning.
(Section 2-2-1-4-11 in [OPERATION])
Set the observation mode.
(Section 2-2-2-5-1 in [OPERATION])
Acquire image.
(Section 2-2-2-5-4 in [OPERATION])
Adjust the image brightness.
(Section 2-2-1-4-9 in [OPERATION])
Set
the interval time.
(Section 2-2-2-5-2 in [OPERATION])
Set the number of scans.
(Section 2-2-2-5-3 in [OPERATION])
Configure the microscope and scan
unit.
(Sections 2-2-1-1 & 2-2-1-2 in [OPERATION])
If the image
does not
become
clean
If the image
becomes
clean
Re-adjust the image brightness.
(Section 2-2-1-4-9 in [OPERATION])
