Olivetti d-Copia 283MF, Operation Manual, Page: 358 / 438

Troubleshooting
10-10 OPERATION GUIDE
Responding to an Error Lamp Flashes
If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated
on the Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check
the following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax. Is the modular cord
connected correctly? Connect the modular
cord correctly. —
Is Permitted FAX No. or
Permitted ID No.
registered correctly? Check Permitted FAX
No. and Permitted ID
No.. FAX Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
Has a communication
error occurred? Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure. FAX Operation Guide
Appendix
"Error Code List"
Is the destination FAX
line busy? Send again. —
Does the destination
FAX machine respond? Send again. —
Is there an error other
than above? Contact your Service
Representative. —