ODA MX Series, User Manual, Page: 43 / 92

▌After briefly displaying the "
Subnet Input" message, the LCD will be switched
to the subnet mask input screen.
Displayed LCD Message
>255.255.255.0
▌Use the cursor key and encoders to enter the subnet mask.
▌Press the IO/Local key after completing input.
▌After briefly displaying the " gate way Input" message, the LCD will be switched
to the gateway input screen.
Displayed LCD Message
>192.168.123.254
▌Use the cursor key and encoders to enter the subnet mask.
▌Press the IO/Local key after completing input.
▌Press the IO/Local Key to complete the settings.
Displayed LCD Message SAVED
This changed the unit’s interface into TCP/IP connection.
*DHCP Method Setting Procedure
▌Turn on the power switch.
After turning on power, check if the unit is in "**OUTPUT OFF**" mode.
▌Press the IO/Local Key for the TCP/IP settings.
Displayed LCD Message I/O> 1.RS232C
This can be different depending
on the previous state.
▌Depending on the previous settings, TCP/IP, RS232C, RS232C, or USB
is displayed while the unit is booting up. If "4.tcp/ip" is not displayed, press the
cursor key to set "I/O> 4.tcp/ip" displayed on the LCD.
Displayed LCD Message I/O> 4.tcp/ip
▌Press the IO/Local Key for the TCP/IP settings.
Displayed LCD Message
>1. Static This can be different depending
on the previous state.
▌There are two methods for setting a fixed IP. You can directly input a fixed IP
or use the DHCP method by receiving an IP from the server.
The procedure below is for the DHCP method settings.
- 40 -
>gate way input
> subnet input