ODA MX Series, User Manual, Page: 18 / 92

2-1. Front-Panel Setting of Voltage and Current
You can set the voltage and current limit values using the following method:
1. After connecting power to power supply, check if “
**OUTPUT OFF**
” is displayed on the LCD.
2. Press the Limit Display Key to switch to Limit Mode.
3. The left cursor key increases the voltage settings value,
and the right cursor key decreases the current settings value.
4. The left encoder changes the voltage settings,
and the right encoder changes the current settings.
5. Rotate the voltage or current encoder clockwise to increase the limit value.
To decrease the limit value, rotate the encoders counter-clockwise.
6. Check if the set values have changed on the LCD display.
7. Press the Output On/Off Key to begin the output of your set voltage and current.
If an error occurs during the『Self-test』, you can check the error by pressing the Error Key.
To check the error codes, refer to “7.Error Messages”
If you are using the remote interface, the front panel's key and encoder switch do not work.
After stopping the remote interface, press the front IO/Local Key to switch to Local mode.
Note1
- 15 -
Note3