Oce CS240, Operation Manual

Page: 544 / 594

13 Utility mode
13-52 CS240/CS231
Punch vertical position adjustment
The vertical position of punched holes when printing with a Punch setting can be adjusted for each paper
size.
2
Note
[Punch Vertical Position Adjustment] appears only if optional finisher FS-517 or FS-608 is installed.
For details on the Punch settings, refer to "Punching holes in copies ("Punch" settings)" on page 4-69.
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-35.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [5 Punch Vertical Position Adjustment].
The Punch Vertical Position screen appears.
6
Touch the button for the paper size to be adjusted.
– If the paper size to be adjusted is not displayed, touch and until the desired paper size is
displayed.
7
Check the sample copy for the punch positions and for the center of the paper.
– If the punch positions are too far above the center of the paper, touch [+] under "Adjust Value" to
increase the adjustment (between 0.1 mm and 5.0 mm).