52
If NO keystroke has been activated for 1 minute, the watch will automatically exit the
setting sequence.
How to use the timer
• Press the [U] button to start the countdown.
• Press the [U] button again to stop the countdown.
• When the timer has counted to zero, the watch will beep 30 times and the timer will go
back to the starting value. You can stop the beeps by pressing the [U] button.
How to reset the timer
• Press the [U] button to stop the countdown.
• Hold the [D] button for 2 seconds to reset the timer to the starting value.
How to go back to current time mode
• Press the [M] button 1 times in countdown timer mode to go back to the current time
mode.
6. Heart rate mode
How to get a heart rate reading
• Wear the watch around your wrist.
• Adjust the transmitter on the centre of your chest
with the supplied elastic band. For men, the chest
strap should be located directly below pectoral
muscles and for women, directly below the breast.
The conductive pads should make firm contact with
your skin and the strap should be tight enough to
avoid loosening it during exercise.
• In most of the cases, skin natural moisture or
sweat is enough to ensure a good contact with the
conductive pads. However, you can moisten the
conductive pads with water, saliva or conductive
gel (available at you local pharmacy).
• Press the [D] button in the current time mode or the
countdown timer mode to get to the heart rate mode.
• When in the heart rate mode, press the [U] button to
activate the measurement. The icon ‘ ‘will
appear and icons ‘ ’ and ‘ ’ will
flash until current heart rate is displayed together with percentage of the maximum