LITE5200B User’s Manual, Rev. 0
Freescale Semiconductor
3-1
Chapter 3
Getting Started
3.1
Steps to Getting Started
1. Make sure all Jumpers are set to the positions as indicated in
Figure 3-1
. No other Jumpers should
be placed on the board.
2. Connect your PC to the 9-pin connector labeled as “UART” ( J3 ) using the supplied serial cable.
3. Connect the 5V power supply supplied with the Lite5200B to the wall outlet.
4. Connect the 5V power supply cable to the J35 Power Connector on the board.
5. Start a terminal application such as HyperTerminal on your PC and set the serial settings to:
•Select Com Port
•Bits per second: 115200
•Handshake/Flow control: NONE
•Data Bits: 8
•Parity: None
•Stop Bits: 1
6. Press the Reset Button labeled “SW2 POR” on the Lite5200B EVB.
7. You should now see the Lite5200B EVB boot messages
1
on the terminal window as described in
Figure 3-2
1. Please be aware that the message “Warning - bad CRC, using default environment” will be indicated when default environment is used.