NXP Semiconductors Lite5200B, User Manual, Page: 101 / 138

REG INFO
LITE5200B User’s Manual, Rev. 0
Freescale Semiconductor 7-51
7.46 REG INFO
The reginfo command is used to interrogate the MPC5200 and return the register values for MBAR, the
LocalPlus Chip Select Start, Stop and Configuration Registers for LP_CS0 - LP_CS7 and LP_CS BOOT,
and the SDRAM Bus Chip Select Configuration Registers. These registers determine the memory map of
the system.
Example:
=> reginfo
MPC5200 registers
MBAR=f0000000
Memory map registers
CS0: start 0000FF00 stop 0000FFFF config 00047800 en 0
CS1: start 0000FE00 stop 0000FEFF config 00047800 en 1
CS2: start 0000FFFF stop 0000FFFF config 00000000 en 0
CS3: start 0000FFFF stop 0000FFFF config 00000000 en 0
CS4: start 0000FFFF stop 0000FFFF config 00000000 en 0
CS5: start 0000FFFF stop 0000FFFF config 00000000 en 0
CS6: start 0000FFFF stop 0000FFFF config 00000000 en 0
CS7: start 0000FFFF stop 0000FFFF config 00000000 en 0
BOOTCS: start 0000FF00 stop 0000FFFF config 00047800 en 1
SDRAMCS0: 0000001A
SDRAMCS0: 0800001A