Invu by Nuvo™
User Manual
The INVU™ App
NV-UMLS-0012
49
Figure 6-26. Apply gel instruction
Wear the INVU Sensor Band
™
Before you put on your band, the app will guide you on how to do it with a step-by-step
guide. After watching all the steps, you’ll be asked to put on your band accordingly:
Stand up and hold the band by its side plastic pods. Make sure the INVU logo is on
the top, in front of the center of your belly, and facing out.
Place the lower strap first, as low as possible yet above your waistband. Placing the
straps directly in their correct location will help you avoid smearing the gel later on.
Use your fingers to gently slide the upper strap as high as possible along your belly.
It should be placed just below your chest.
Pull the side plastic pods as far back as possible. The side plastic pods should be on
each side of your torso, in line with your armpits.
Slide your hands behind your back to close the back buckle. Tighten by pulling one
back strap and then the other. The band should be snug on your belly, tight without
being uncomfortable. Make sure all the buckles are securely fastened.Tighten all 4
front straps so the sensors are touching your skin completely. Open the upper
strap's buckles, pull the straps toward your sides, and then close the buckles. Do
the same with the lower straps.