Novexx Solutions ALS/XLS 204, Service & Installation Manual

Page: 232 / 312

Service Manual
ALS/XLS 20x/256/272
02/2019 | 01 232 Fault description
5001 No gap found
– Material end, if no outer diameter
(OD) control is activated.
– The maximum limit for missing la-
bels was exceeded ( LABEL SETUP >
Miss. label tol. ).
– The machine is not correctly set
for the type of label ( MACHINE SE-
TUP > Label sens. type ).
– Label length is not correctly set
( LABEL SETUP > Label pitch ).
– Photoelectric label sensor is dirty.
– Photoelectric label sensor is incor-
rectly positioned.
– Photoelectric label sensor is not
connected correctly.
– Photoelectric label sensor is de-
fective.
– Rotary encoder is not adjusted
correctly.
 Check the points listed above and
correct if necessary.
 Press the button to confirm
the error message.
5002 Material end
– Material end (if the internal OD-
control is activated).
 Insert new label roll.
5009 Start error
– Refers to the standard start sensor
input (M12).
– The device received another start
signal while applying a label.
– Prerequisite:
MACHINE SETUP > Start
error stop
is set to “On” .
 Check the operation of the labeler;
increase distance between prod-
ucts if required.
 Set
MACHINE SETUP > Start error stop
to “Off”.
5019 Startsig. overrun
– Too high start signal frequency
caused start signal buffer over-
flow.
– Possible causes: Distance be-
tween product sensor and dis-
pensing edge is too high and/or to
high product
 Decrease distance between prod-
uct sensor and dispensing edge.
 Decrease dispensing/conveyor
speed.
 Increase product distance.
Status Status text Cause Action to take