AFP-400 Installation
PN
50253
:
A2 03/12/96
2-17
Installing Expander Modules (CRE-4, ICE-4, VCE-4) into a Chassis
1) Remove ONE module support
screw and set it aside for later
use.
2) Replace screw with one module
standoff.
4) Insert pins on the Expander
Board into connector on the
module. Make sure the pins are
in line, then press the two
boards together until the boards
snap into place.
3) Repeat Steps 1 and 2 for the
three remaining screws on the
module.
Module
Expander
Board
5) Install the four screws removed
earlier through the back of the
Expander Board and into the
standoffs.
