AFP-400 Installation
PN
50253
:
A2 03/12/96
2-7
Mounting a Backbox
Mount a cabinet on a surface in a clean, dry, vibration-free area. To install
the cabinet so the center of the control panel keypad measures 60 inches
above the finished floor, follow these instructions:
1) Locate the cabinet so that the top edge is 66 inches above the surface of
the finished floor.
2) Mount the backbox using the four mounting holes in the back surface of
the backbox.
Overview
!
Caution:
Unless you are familiar with the placement of components within
this backbox, use only the knockout locations provided for conduit entry.
Step Action
1
Remove the main PC board assembly by unscrewing the four screws
in the corners of the board. Two permanent standoffs support the
main PC board in the center.
2
Mark and predrill holes for the top two keyhole mounting bolts.
3
Install two upper fasteners in the wall so the screw heads protrude
approximately 1/2".
4
Using the upper keyholes, mount the backbox over the two screws.
5
Mark the lower two holes, remove the backbox and drill the
mounting holes.
6
Mount the backbox, then install and tighten the remaining fasteners.
7
When the location is dry and free of construction dust, reinstall the
main PC board.
Mounting a Cabinet Backbox
Mounting
holes
4 places
When removed, place the
main PC board in a safe,
clean place. Avoid static
discharge which can
damage the board.
!
