Nortel 4050, User Manual

Page: 56 / 922

56 Chapter 2 Initial setup
320818-A
used if no other interface is specified. The default gateway IP address on
Interface 2 must be within the same subnet as the RIP for Interface 2.
10 Specify the MIP for this device or cluster.
The MIP must be unique on the network and must be within the same subnet
as the RIP and the default gateway for Interface 1.
11 Specify the time zone.
If you do not know the time zone you need, press
<CR>
to access the selection
menus:
Note: If you receive an error message that the iSD (the Nortel
SNAS 4050 device) cannot contact the gateway, verify your settings on
the core router. Do not proceed with the initial setup until the
connectivity test succeeds.
Enter port number for the traffic interface [1-4]:
< port >
Enter IP address for this machine (on traffic interface):
< IPaddr >
Enter network mask [255.255.255.0]: < mask >
Enter VLAN tag id (or zero for no VLAN) [0]:
Enter default gateway IP address (on the traffic
interface):
< IPaddr >
Enter the Management IP (MIP) address: < IPaddr >
Making sure the MIP does not exist...ok
Trying to contact gateway...ok
Enter a timezone or 'select' [select]: < timezone >
Select a continent or ocean: < Continent or ocean by
number >
Select a country: < Country by number >
Select a region: < Region by number, if applicable >
Selected timezone: < Suggested timezone, based on your
selections >