Nortel 4050, User Manual

Page: 469 / 922

Chapter 10 Configuring system settings 469
Nortel Secure Network Access Switch 4050 User Guide
Viewing host information
To view the host number and IP address for each Nortel SNAS 4050 device in the
cluster, use the
/cfg/sys/host < host ID >/cur
command.
Configuring host interfaces using the CLI
The default IP interface on the Nortel SNAS 4050 host is Interface 1. You can
create additional interfaces and specify the ports to be assigned to each interface.
If you assign more than one port to an interface, you can choose whether the ports
will operate in failover or trunking mode.
You can create a maximum of four interfaces on each Nortel SNAS 4050 host.
To configure an IP interface and the assignment of physical ports on a particular
Nortel SNAS 4050 host, use the following command:
/cfg/sys/host < host ID >/interface < interface ID >
where
interface ID
is an integer in the range 1 to 252 that uniquely identifies
the interface on the Nortel SNAS 4050 host. To configure a new interface, enter an
unused interface ID number. To change the configuration of an existing interface,
enter the applicable interface ID number.
The Host Interface menu displays.
The Host Interface menu includes the following options:
/cfg/sys/host #/interface < interface ID >
followed by:
ip < IPaddr >
Sets the network address for the interface. (For
Interface 1, the network address is the RIP.)
netmask < mask >
Sets the subnet mask for the interface.