Nokia IP60 - Security Appliance, User Manual

Page: 27 / 494

Nokia IP60 Products
Chapter 1: Introduction 27
Label Description
Serial A serial (RS-232) port used for connecting computers in order to access the
Nokia IP60 CLI (Command Line Interface), or for connecting an external dialup
modem.
Depending on the appliance model, this port may have either a DB9 RS232
connector, or an RJ-45 connector. In models with an RJ-45 connector, an RJ-45
to DB9 converter is supplied for your convenience.
Warning:
Do not connect an Ethernet cable to the RJ-45 serial port.
WAN Wide Area Network: An Ethernet port (RJ-45) used for connecting your
broadband modem, a wide area network router, or a network leading to the
Internet.
DMZ/
WAN2
A dedicated Ethernet port (RJ-45) used to connect a DMZ (Demilitarized Zone)
computer or network. Alternatively, can serve as a secondary WAN port or as a
VLAN trunk.
LAN 1-4 Local Area Network switch: Four Ethernet ports (RJ-45) used for connecting
computers or other network devices.
ANT 1/
ANT 2
Antenna connectors, used to connect the supplied wireless antennas .
Front Panel
The Nokia IP60 Wireless appliance includes several status LEDs that enable you to monitor the appliance’s
operation.
For an explanation of the Nokia IP60 Wireless appliance’s status LEDs, see the table below.
Table 6: Nokia IP60 Wireless Appliance Status LEDs
LED State Explanation
PWR/SEC Off Power off
Flashing quickly (Green) System boot-up
Figure 5: Nokia IP60 Wireless Appliance Front Panel