(
15
)
Card Jan in the Flip Turn Block
Card JAM. F.
Turn Area08
Er - Ad
Er Ad Symptom
Check/Repair
46
**
Card jam error in the
Area 08
(
SN15
)
when the
card is transported from
Flip Turn to Encoder or
from Encoder to Flip
Turn.
(
1
)
Check that the card is staying in the
problem area. If no card, go to
(
*b
)
.
(
2a
)
After removing the staying card, check
the motion of PM2, in the Actuator
Check Mode. If normal, clean the
transport rollers of flip turn block.
Check that there is "Encoder Check" menu
in the
service mode.
If there is not "Encoder Check" menu, the
printer
does not recognize the Encoder.
Then see section 6.2
(
Errors which can not
be checked on the LCD panel.
)
(
3a
)
If PM2 does not work normally, check
connection and electrical contact of the
harness.
·
ASM-MOTOR
(
4a
)
If the harness connection is normal,
replace the
following:
·
PM2
·
PBA-MAIN
(
2b
)
Check the reaction of SN15 in the
Sensor Check Mode.
(
3b
)
If SN15 does not react, check connection
and electrical contact of the harness.
·
ASM-EN-RELAY
·
ASM-ENC
(
4b
)
If the harness connection is normal,
replace the following:
·
SN15
·
PBA-MAIN
