47
CHECK AND ADJUSTMENT PROCEDURES
:
Bevel Width and Height Adjustment for Step Beveling (Type
3
3.12
Bevel Width and Height Adjustment for Step Beveling (Type PLB-8S only)
■
Change the parameters when the bevel width and height are different from the specified value in
step beveling.
3.12.1 Bevel width in step beveling
1
Check the bevel width.
1) Load the circle 45 internal data and process a lens with 2 mm in step width and 1.5 mm in
step height.
Process a lens of CR39 and -4 to -5 D.
2) Check that the bevel width of the processed lens is the same as the setting.
2
When the bevel width is not 2 mm, change the
parameter in the following procedure.
1) Display the menu screen in service mode. See
“3.2.1 Entering service mode” (page 16).
2) Press the Grinding tab on the menu
screen.
The Grinding screen is displayed.
3) Press the Adjustment button.
4) Press the Hi-curve button.
5) Press the "Wheel position" numeric
field.
The numeric keypad appears.
6) Change the parameter value.
Enter the value and press the
but-
ton with the numeric keypad.
Increase the value.
⇒
The width
becomes narrower.
Decrease the value.
⇒
The width becomes wider.
3
Press the Exit tab to return to the layout screen.
4
Repeat Steps
1
to
3
until the bevel width becomes proper.
Bevel width
2)
2)
3)
3)
4)
4)
5)
5)
Summary of Contents for ME 1200
Page 6: ...IV ...
Page 10: ...2 REQUIREMENTS Requirements ...
Page 58: ...50 CHECK AND ADJUSTMENT PROCEDURES Clock Check ...
