34
CHECK AND ADJUSTMENT PROCEDURES
:
Axis Adjustment
3.7.2
Safety bevel amount is not consistent
■
When the safety bevel amount of the processed lens is not consistent in circumference after the
shifted axis angle is adjusted “3.7.1 Adjusting the axis shift” (page 32), the safety bevel axis may
be shifted. Adjust the safety bevel axis angle.
1
When the safety bevel amount is different between the upper right and upper left of the
processed lens, change the "Rear, Flat" or "Front, Flat" parameter to adjust the safety
bevel axis angle.
1) Display the menu screen in service mode.
See “3.2.1 Entering service mode” (page 16).
2) Press the Grinding tab on the menu
screen.
The Grinding screen is displayed.
3) Press the SFB setting button
The SFB setting parameters are dis-
played.
2
Set the safety bevel amount on the SFB
axis parameter.
1) Press the SFB axis button.
2) Press the "Rear, Flat" numeric field.
The numeric keypad appears.
3) Change the parameter value with the
numeric keypad. Enter the value and
press the
button.
When the safety bevel amount of the upper right is larger when viewed from the rear surface,
increase the value. When the safety bevel amount of the upper left is larger, decrease the value.
2)
2)
3)
3)
1)
1)
2)
2)
㸩
㸫
Rear
surface
The safety bevel amount of the
upper left is larger.
The safety bevel amount of the
upper right is larger.
Summary of Contents for ME 1200
Page 6: ...IV ...
Page 10: ...2 REQUIREMENTS Requirements ...
Page 58: ...50 CHECK AND ADJUSTMENT PROCEDURES Clock Check ...
