Nidek Medical LE-9000DX Express, Operator'S Manual

Page: 57 / 153

4 - 27
4.5.1.4 EX lens processing mode
This mode serves to process EX lenses. In this mode, the beveling which has the curve profiling
the rear surface is performed.
As for a cataract lens which has a large dilation on its front convex surface, edge a lens in the EX
lens edging mode if the lens processing cannot be performed in the guided processing mode (rear
base curve) due to a lens shape measurement error.
NOTE
• Use a lens cup for blocking.
A suction cup cannot hold the convex surface of a lens securely enough. The cup
may move during blocking.
1. Check the processing conditions.
: MTL or CEL (ZYL)
: EX
2. Set a lens to the adapter in the processing unit.
See Step 2 of “4.5.1.1 Auto processing mode”.
3. Close the soundproof cover.
Processing does not start even if is pressed unless the soundproof cover is closed.
WARNING
• Be sure to keep the soundproof cover closed while processing a lens.
If the soundproof cover is opened during processing, the instrument will not stop.
Spray including processing waste may damage your eyes.
4. Press .
Lens shape measurement
↓
The screen changes to the Bevel simulation screen and the instrument stops.
㧲㧼㧰㧦㧢㧥㧜㧜ޓޓޓޓޓޓޓޓ 㧲㧼㧰㧦㧢㧥㧜㧜ޓޓޓޓޓޓޓޓ
㧼㧰 㧼㧰ޓ㧦㧢㧞㧜㧜ޓޓޓޓޓޓޓޓ 㧦㧢㧞㧜㧜ޓޓޓޓޓޓޓޓ
ޓޓޓ㧦ޓޓ㧞㧜ޓޓޓޓޓޓޓޓ ޓޓޓ㧦ޓޓ㧞㧜ޓޓޓޓޓޓޓޓ
㧿㧵㨆㧦ޓ㧜㧜㧜ޓޓޓޓޓޓޓޓ 㧿㧵㨆㧦ޓ㧜㧜㧜ޓޓޓޓޓޓޓޓ
㧭㧯㨀ޓޓޓޓޓޓޓޓޓޓޓޓޓ 㧭㧯㨀ޓޓޓޓޓޓޓޓޓޓޓޓޓ
㧹㧱㧹 㧹㧱㧹㧦ޓޓޓޓޓޓޓޓޓ 㧦ޓޓޓޓޓޓޓޓޓ
㧼㧸㧭 㧼㧸㧭㧹㨀㧸㧱㨄ޓ 㧹㨀㧸㧱㨄ޓ ޓ㧾 ޓ㧾
㧚ޓ
㧚ޓ
ޓ㧚
㧚ޓ
㧹㧵㧺ޓޓ㧢㧡