Nidek Medical LE-9000DX Express, Operator'S Manual

Page: 56 / 153

4 - 26
3. Restart processing.
Press to restart processing.
If the bevel is completely off the lens edge, two short beeps will sound. The sectional view
position line automatically rotates along the whole traced outline and the bevel section at each
position will be shown.
Change the setting as necessary. To process the lens without changing the setting, press
again.
This function works when more than half of the bevel is off the lens edge.
After roughing and finishing, processing sequences are over. The Layout screen returns.
4. Remove the lens.
WARNING
• Open the soundproof cover after making sure that the wheels have stopped completely.
• Release the chuck by pressing after making sure that the wheels have stopped
completely.
When the chuck is released before the wheels have stopped completely, if a lens is
dropped, it may contact the turning wheels and its scattering may cause an injury.
5. When subsequently processing the other lens by switching R or L, the former setting for
the lens will be shown on the screen.
If one lens is processed with the tilting function, the Bevel simulation screen will automatically
appear after the other lens is edged by switching R or L. The former values such as the tilt base
position, amount of tilting bevel, bevel curve and bevel tip point are initially displayed.
NOTE
• If the front base curve (FRNT), rear base curve (REAR) or Ratio is selected as the
bevel curve, the amount of bevel tilting will be ignored. The lens will be processed in
the normal guided processing mode.
• With the tilting function, the bevel curve will be calculated from the spherical curve of
the lens. For the reason, the bevel may be off the edge even though the closer value to
the auto-curve value is set.
• If the lens is edged with the bevel curve value with A on condition that the parameter
“Tilt Function” is set at “Exec”, the parameter setting will be ineffective, and the bevel
tilting function does not work.