Nidek Medical LE-9000DX Express, Operator'S Manual

Page: 27 / 153

3 - 8
Size compensation value (SIZ)
Indicates the compensation value for the
desired finished size in diameter, based on
the traced size of the frame or pattern
(0.00).
[–9.95 - +9.95 mm (increment: 0.05 mm)]
Layout mode
Indicates the selected layout mode [ACT
(active mode), BF (bifocal mode), or PAS
(passive mode)].
Memory address (MEM)
This address is used to store or to read
traced pattern data when the memory func-
tion is used. See “5.4 Storing and Calling
Up Traced Data (p. 5-7)”.
The indication of an address whose data
has already been stored is highlighted.
* This is not shown depending on the pa-
rameter setting of “Ext. interface”.
Lens material
The specified lens material [PLA (plastic),
HPL (high index plastic), PC (polycarbon-
ate), GLS (glass), ACR (acrylic resin) or
TRX (trivex)] is indicated.
Frame material
[MTL (metal), CEL (celluloid)/ZYL, PNT
(two-point), or NYL (nylor)].
Processing mode
Indicates the processing mode.
[AUT, GUI, EX, or (Blank)]
(Blank) indicates flat edging without a
groove.
Polishing indication
Indicates the polishing mode.
Frame changing indication
Indicates the simple frame changing mode.
R/L indication
Indicates the selected lens to be processed
[R/L].
Traced outline
Represents the plain figure of a traced out-
line in actual size.
Minimum lens diameter (MIN)
Indicates the minimum lens diameter re-
quired for processing. It appears when data
of to are entered.
SFB indication
(LE-9000EX Express only)
When the SFB mode is selected, or
is shown.
→
Both lens edges are chamfered.
→
Rear lens edge is chamfered.
Setting of or can be changed in the
SFB mode of the Groove & SFB adjust-
ment parameter. See “8.13.1 Setting the
SFB mode and chamfering amount (p. 8-
31)”.
Soft processing mode indication
Indicates the soft processing mode.
Rim center
Represents the position of the rim center.
Optical center ( )
Represents the position of the optical cen-
ter.
In the bifocal mode, the segment
ap-
pears instead of the optical center.
Up direction (
J J J J J
)
Represents the direction in which the mark
on the blocked cup faces.
Top mark