New Holland T6010 DELTA, Operator'S Manual

Page: 263 / 412

SECTION 3 -- FIELD OPERATION
3--129
The sectioned drawings shown, illustrate the wheel
rim and disc positions relative to the hub at various
track settings.
IMPORTANT: When interchanging left and
right--hand wheel assemblies, ensure the “V” of the
tread at the top of the tyre remains pointing in the
direction of forward travel.
When refitting or adjusting a wheel, tighten the bolts
to the following torques then re-check after 50 hours
of operation and thereafter as required.
Rear disc to hub nuts 250 Nm (184 lbf. ft.)
Rear disc to rim nuts
M16 nuts 250 Nm (184 lbf. ft.)
Track Settings
Adjustable Rim (Types 1 and 2)
Track
setting
Figure 224
All Models
34” and 38” Wheels
Figures 221, 222
A 1412 mm (55.5 in.)
B 1510 mm (59.4 in.)
C 1614 mm (63.5 in.)
D 1710 mm (67.3 in.)
E 1812 mm (71.3 in.)
F 1910 mm (75.1 in.)
G 2014 mm (79.2 in.)
H 2110 mm (83.0 in.)
NOTE:
With the larger tyre sizes, the narrower track
settings may not be attainable due to minimal
clearance between tyres and fenders or equipment.
The dimensions shown in the above chart relating
to Figure 224 are nominal and should be used as
a guide only. Track settings may vary dependent
upon wheel type and tyre size.
A
B
C
D
E
F
G
H
224