New Holland T6010 DELTA, Operator'S Manual

Page: 177 / 412

SECTION 3 -- FIELD OPERATION
3--43
POSITION CONTROL OPERATION
IMPORTANT: Always set the system to Position
Control at any time when not actually operating in
Draft Control, such as when attaching or transporting
equipment or when no equipment is attached.
Move the Draft Control lever (3), fully forward in the
quadrant. Set the required implement height/depth
using the Position Control lever (2). Pull the lever
back to raise the implement, push forward to lower.
Implement height/depth is relative to the position of
the lever in the quadrant.
71
To raise the implement at the end of each pass, or
whenever required, move the latch (1) rearward to
release the fast raise button. The button (2) will pop
out, as shown and the 3--point linkage (and
implement) will raise to full lift height (as determined
by the height limiter cam setting) without the need to
move the Position Control lever.
To lower the implement, simply press the fast raise
button (2) fully in, as shown, and the implement will
lower to the height/depth set by the Position Control
lever.
72
CAUTION
When transporting equipment on the 3--point
linkage, raise the implement using the Position
Control lever. The hydraulic system will maintain the
equipment at the height set by the Position Control
lever and prevent the equipment lowering and
becoming damaged, damaging the road surface or
causing personal injury.