New Holland T6010 DELTA, Operator'S Manual

Page: 81 / 412

SECTION 2 -- CONTROLS, INSTRUMENTS AND OPERATION
2--53
Auto Calibration with Enhanced Keypad
(where fitted)
•
With the the tractor stationary and the engine
running, depress and hold the Menu/Enter key
(4) for 3 seconds. The DMD will read
SETUP_MENU, this will change to CAL after 2
seconds. Depress the Enter key again and CAL
manual will appear. Using the Menu Up key (1),
scroll through the menu until CAL auto is
displayed.
•
Depress the Menu/Enter key again and CAL
auto READY will appear in the DMD. Select a
suitable transmission ratio to provide a forward
speed above 3 km/h (1.8 MPH). As the centre of
the front tyres passes over the start line, press
and release the Menu/Enter key. The speed
display will start to flash CAL and the central LCD
will show a four digit figure that will increase as the
tractor moves forward. The DMD will change to
display CAL auto ON .
96
•
As the centre of the front tyres passes over the
finish line, press and release the Menu/Enter
key.
CAL auto OK
will appear in the Dot Matrix
Display. Depress the Menu/Enter key to store the
setting. Press and release the Exit/Cancel key (2)
Figure 96, to return to the original display.
97