New Holland T6010 DELTA, Operator'S Manual

Page: 172 / 412

SECTION 3 -- FIELD OPERATION
3--38
Transport Position
The top link and lower links should be placed in the
transport position when not in use. Raise the top link
(1) to the vertical position and secure by inserting the
lock pin (2) through the top link and anchor bracket.
Secure the pin with the spring clip as shown.
59
Each lower link pivots about the pivot bolt (2). The
pivot bolt should not be removed unless it is required
to remove the lower links. Extract the lower pin (3)
from the link assembly and raise the lower link (1) to
the vertical position, as shown. Insert the pin through
the upper hole in the inner link arm when the holes
in the inner and outer links (4) are correctly aligned.
Before operating the tractor ensure both pins are
secured with lynch--pins.
60
To convert to the working position, remove the
lynch--pin, pull out the pin (5) and manually lower the
link arm down to the operating position, as shown.
Install the removed pin in one of the holes (6) or (7),
as required.
When installed in the rear hole (6) as shown, the
lower link will be locked as a rigid unit. If the pin is
installed in the front hole (7), the lower link will be
allowed to move up and down freely (float) through
a range of approx. 75 mm (3 in). Secure the pin with
the lynch--pin.
Repeat on the other lower link, ensuring that both
lower links are set up the same, i.e., both are locked
as rigid units or both are allowed to float.
61