New Holland T6010 DELTA, Operator'S Manual

Page: 144 / 412

SECTION 3 -- FIELD OPERATION
3--10
STOPPING THE ENGINE
IMPORTANT: Before stopping, idle the engine at
1000 rev/min for approximately one minute. This will
allow the turbo--charger and manifold to cool and
prevent possible distortion of components.
To stop the engine, carry out the following procedure:
•
Sit in the driver’s seat.
•
Close the throttle.
•
Ensure that the parking brake is firmly applied.
•
Ensure that all gearshift levers are in neutral.
•
Ensure the P.T.O. is disengaged.
•
Place the remote control valve levers in the
neutral position.
•
Lower 3 point hitch mounted equipment to the
ground.
•
Turn the key--start switch off -- position (2).
AUTOMATIC ENGINE SHUTDOWN
(where fitted)
Automatic engine shutdown is standard on tractors
equipped with the optional Enhanced Keypad.
The system monitors four key areas that are critical
to the safe operation of engine and driveline and, in
the unlikely event that one or more of these reaches
a critical level, the engine will be shut down.
•
Engine oil pressure falls below safe limits.
•
Engine coolant temperature exceeds safe limits.
•
Driveline oil pressure falls below safe limits.
•
Driveline oil temperature rises above safe limits.
Prior to engine shutdown the red Stop light will start
to flash and the critical alarm will sound. In addition,
the engine fault warning and malfunction symbols
will flash alternately in the Dot Matrix Display. If, after
30 seconds, the operator has not stopped the
engine, the automatic shutdown feature will be
activated and the engine will be shut down.
9