New Holland T6010 DELTA, Operator'S Manual

Page: 264 / 412

SECTION 3 -- FIELD OPERATION
3--130
Fixed Rim (Type 3)
A track adjustment of approximately 50 mm (2.0in.)
each side, may be achieved by interchanging wheel
assemblies.
Track
setting
Figure 225
Disc type 3
(18.4 x 38 tyre)
Figure 223
A 1730 mm (68.1 in.)
B 1834 mm (72.2 in.)
NOTE: Depending on rim type, the above settings
may vary by approximately 10.0mm (0.4 in.).
A
B
225
TOBACCO AXLE
(North America only)
If your tractor has the optional Tobacco axle, then the
track settings shown in the table on page 3--129 are
increased by 152 mm (6 in) by the addition of spacers
between the wheels and the rear axle flanges.
When refitting or adjusting a wheel, tighten the bolts
to the following torques then re-check after 50 hours
of operation and thereafter as required.
Disc to hub nuts 250 Nm (184 lbf. ft.)
Disc to rim nuts 250 Nm (184 lbf. ft.)
Track
setting
Figure 224
Tobacco Axle
34” and 38” Wheels
Figures 221, 222
A 1564 mm (61.5 in.)
B 1662 mm (65.4 in.)
C 1766 mm (69.5 in.)
D 1862 mm (73.3 in.)
E 1964 mm (77.3 in.)
F 2062 mm (81.1 in.)
G 2166 mm (85.2 in.)
H 2262 mm (89.0 in.)