SECTION 3 -- FIELD OPERATION
3--80
Operating Several Remote Valves
Simultaneously or Remote Valves and
Hydraulic Lift Simultaneously
If operating two or more remote control valves
simultaneously or remote valves and the hydraulic
lift, the flow through the valves should be adjusted
using the enhanced keypad to provide a partial flow,
as previously described. If not so adjusted, all the
available flow may be directed to the full flow circuit
when the pressure in that circuit is less than that of
the other circuits in use.
NOTE:
The oil flow (1), Figure 138, through remote
valve number one (lower valve) will always take
priority over the other valves. For equipment using
more than one remote valve, the hydraulic service
with the highest priority should be connected to valve
number one.
1
2
137
138
Bleeding Remote Cylinders
When connecting a cylinder with trapped air, i.e., a
new cylinder, one that has been out of service or one
that has had the hoses disconnected, it will be
necessary to bleed the cylinder to remove the air.
With the hoses connected to the remote control valve
couplers at the rear of the tractor, position the
cylinder with the hose end uppermost and extend
and retract the cylinder seven or eight times using the
remote control valve operating lever.
Check the rear axle oil level before and after
operating a remote cylinder.
Summary of Contents for T6010 DELTA
