Netscout OneTouch AT G2, User Manual

Page: 163 / 396

Chapter 5: User Tests
Wi-Fi Performance Test
147
Type - Select “This OneTouch” from the list. See “Configuration”
on page 130.
The Name button allows you to assign a custom name to the test.
See also: “Name” on page 105 .
Target Rate - This is the requested rate of upstream traffic.
Valid rates are from 1 Mbps to 600 Mbps.
Target Rate - This is the requested rate of downstream traffic.
Valid rates are from 1 Mbps to 600 Mbps.
Loss Limit is the percentage of frames that can be lost. If this value
is exceeded, the test will fail.
Duration is the length of time the test will run. You can run a
quick one second test or up to a full minute of testing.
Frame Size is the size of the frames that the OneTouch analyzer
will exchange with the endpoint. The header is included in the
frame size.
The DSCP (Differentiated Services Code Point) control allows for
verification of higher quality of service (QoS) for applications such
as VoWiFi. Using the DSCP control, you can specify a priority for
the generated traffic by changing its classification. This is a six-bit
field. The default value of zero specifies “best effort.”
Port specifies the base port used by the test.
To run as the Peer Test Type
At the source OneTouch analyzer, in the Wi-Fi Performance test’s
setup tab, ensure all options are set as described below.
Type - Select Peer from the list. See “Configuration” on page 130.
Peer - Enter the IP address of the endpoint to which you will be
connecting.
The Name button allows you to customize the test name. See also:
“Name” on page 105 .