NEC SigmaBlade N8406-040(F), User Manual

Page: 188 / 206

Appendix: Saving/Restoring Setting Values
Saving/Restoring Setting Values
Information set on the 8G FC Switch can be saved or reset by using the configupload or
configdownload command.
IMPORTANT:
„ To run commands saving the setting of the 8G FC Switch, an FTP server is required
additionally. Prepare a proper FTP server before saving.
„ The configupload and configdownload commands do not change the name and IP
address of the 8G FC Switch. After executing configdownload, change them by using
respective commands.
NOTE:
„ Saving of settings on 8G FC Switch is required in system recovery including device
replacement due to a system fault. If a new 8G FC Switch is installed or some setting
on an 8G FC Switch is changed, save the settings on the 8G FC Switch.
1.
Transmit setting file to FTP server.
Using the "configupload" command allows a setting file to be transmitted to the FTP server.
Format of "configupload" command
configupload
←
Command
Protocol (scp, ftp, local) [ftp]:
←
Transmission protocol
Server Name or IP Address [host]:
←
IP address of FTP server
User Name [user]:
←
User name of FTP server
Path/Filename [<home dir>/config.txt]:
←
File name
Password:
←
Password of FTP server
NOTE:
„ The values in angle brackets ([ ]) are defaults.
- 188 -