NEC SigmaBlade N8406-040(F), User Manual

Page: 143 / 206

Appendix: Connecting Serial Port
The 8G FC Switch includes the feature of logging in to the console of the 8G FC Switch via a serial port
to provide setting for the 8G FC Switch.
To use a serial console, the following jobs are previously required.
Connecting Serial Console
You should login to the serial console of the 8G FC Switch from the console of the Enclosure
Manager (EM) card in the Blade Enclosure (SIGMABLADE). For the login from the console of the
EM card in the Blade Enclosure (SIGMABLADE), refer to the User’s Guides of the Blade Enclosure
(SIGMABLADE) and EM card.
The parameters required to connect to the serial port installed on the 8G FC Switch should be set
as shown in the table below:
Transmission speed 9600 bps
Data length 8 bits
Parity None
Stop bit 1 bit
Flow control None
The user name and password for the initial login to the console on the 8G FC Switch are as
follows:
Administrator authority: Display of 8G FC Switch setting information and setting change
User name for 8G FC Switch login: admin
Password for 8G FC Switch login: password
User authority: Display of 8G FC Switch setting information
User name for 8G FC Switch login: user
Password for 8G FC Switch login: password
NOTE:
„ Type the user names and passwords for 8G FC Switch login with lowercase
letters.
„
For security change the default password to new one.
„ For the serial login to the 8G FC Switch from the EM card in a Blade Enclosure
(SIGMABLADE) through Ethernet, refer to the User's Guides of the Blade
Enclosure (SIGMABLADE) and EM card.
- 143 -